Bench Update: 1/4222 Venator progress

More pics of the master build.  There were some issues with the warping of the top pieces so I put supports on them, only to find out that they bulged a little in the center and ended up being uneven at the rear.  THAT section has been a whole other headache, too…the tail angles were off in my designs so I had to rebuild it twice before acceptable ground was reached.  The upper hull fins that go above the engines are still in question, since they will leave some severe undercuts (bad for casting).  Anyway, here is the progress, as mentioned.

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s